Skip to main content
KitchenAid Product Help

Tips for making perfect ice cream

Fit

  • Check the KICA for fit on the mixer before freezing it.
  • It should be used immediately when removed from freezer, so this will help the attaching process when frozen go more quickly.
  • Do not store the drive assembly in the freezer with the freeze bowl. This will harden the inner rubber grips on the drive assembly so they will not have any "give" to allow for pressing on the planetary action.
  • If the drive assembly is not coming into full contact with the dasher you may adjust the beater to bowl clearance.

NOTE:  The drive assembly does not fit tightly on the shaft of the mixer.

  • It presses onto the planetary action of the mixer, but does not click in place.
  • It may need to be held in place while the motor head is lowered or the bowl is raised until it contacts the dasher.

 

  • If your mixer has a DC motor or is a European model, and the drive assembly does not fit, please contact us.

 

US Ice Cream Adaptor.jpgGlobal Adaptor.jpg

 

 

Bowl/batter temperature

  • The freeze bowl must be completely frozen to make ice cream or frozen desserts.
    • Place the bowl in the freezer for a minimum of 15 hours.
    • It is best to store the freeze bowl at the back of the freezer where it is the coldest.
    • If the bowl is not completely frozen after the 15 hours have the consumer make sure that the freezer is on the coldest setting.
    • The freeze bowl should be used immediately after removal from the freezer. Even a few minutes out of the freezer before using will affect your results.
  • Ice Cream batter should be cooled to refrigerator temperature before freezing in the KICA.
  • "Cooked" recipes should be cooled at least 8 hours before freezing in the KICA.
  • Have the ice cream bowl attached and the mixer running before pouring in the ice cream mixture.
  • Batter volume grows significantly during freezing. The initial batter should not exceed 46 oz. to produce 2 quarts of ice cream.

For a creamier ice cream

  •  Use a cream with a higher fat content. Low fat creamers will make the end texture grainy.
  • Add solid ingredients, such as fruit, nuts, and candies, 12 - 15 minutes into the freezing process.

The ice cream process

  • Ice Cream making is a two-part process: "conversion" and "ripening."
    • After conversion (freezing with the KICA) the ice cream will be a "soft serve" consistency.
    • The "ripening" process takes place in the freezer, where the ice cream will harden over a period of 2 - 4 hours.

Removing/storing the ice cream

  • Ice cream will be a soft-serve consistency and can be served immediately.
  •  If you prefer a harder ice cream, put the mixture in a shallow container for freezing.  Ice cream should be removed from the bowl with a non-metallic spoon or spatula.
  • Storing the ice cream in the freeze bowl will create "rock" hard ice cream that will be difficult to remove from the bowl and may cause damage to the bowl if a metal scoop or utensil is used.

Clicking noise

Means the ice cream is done!  If you continue to stir, the ice cream will start to melt.

 

Leaking Blue Gel

 

The blue gel found inside the ice cream maker attachment is nontoxic, but if it is leaking, please contact us.

  • Was this article helpful?