Does your Water Filter need to be Replaced?
A clogged or incorrectly installed water filter will reduce the water flow to the ice maker, which will result in small ice cubes or low ice production.
If the refrigerator has a water dispenser, check for a problem with the filter by doing the following:
- Dispense water using the water dispenser and note the amount of water flow.
- Remove the filter. The filter is located either in the base grille below the refrigerator compartment door or inside the refrigerator compartment.
- Dispense water with the filter removed. If the water flow noticeably increases, the filter is either clogged or incorrectly installed. A clogged filter will need to be replaced in order to correct the low flow.
If the filter is clogged and you are not able to immediately replace it, leave the filter out so the water system is in bypass mode. With the filter removed, the water system will continue to operate, bypassing the filter, and the clogged filter will not cause slow water dispensing or low ice production. However, in order to have filtered water, you will need to install a new filter.
REMINDER: Make sure you flush the system after replacing your water filter. Air in the water lines can cause the water dispenser to drip. Flush the water system to remove the air in the water lines. Flushing the system is needed every time the filter is changed or once the refrigerator is hooked up to the water supply line for the first time.To purchase water filters, visit EveryDropWater.com. Their filter selection tool will help you identify the right filter for your refrigerator or icemaker.