Home
Cooking
Wall Ovens and Ranges
Product Info
Oven Product Assistance
Using the Wireless Remote Timer and Thermometer

Using the Wireless Remote Timer and Thermometer

Last updated
Save as PDF
Share
1. Share
2. Tweet
3. Share

How to Use the Wireless Remote and Meat Probe in My KitchenAid Oven

Install the Batteries

There is a strip under the battery cover to prevent battery drain in shipping. Please remove the strip before continuing with these instructions (you may need to remove the battery compartment to avoid breaking the strip).

Remove the battery cover on the back of the thermometer.
Insert 4 AAA 1.5 V batteries as indicated by the polarity symbols (+ and -).
Replace the battery cover.

To preserve the batteries, turn both units ON when in use and OFF when not in use. If readings grow dim or irregular, the batteries may need to be replaced.

Replacing the batteries after removing battery cover on back of the thermometer

Using the Meat Probe

Wireless Remote Timer and Thermometer Components:

wireless thermometer handheld unit Meat probe and connector plug

Connect the meat probe. Locate the probe port on the side of the thermometer (Transmitting Base). Insert the probe connector plug into the port (See Fig. 1).

Inserting meat probe connector plug in the port

Turn it "ON". Turn on Handheld Unit and Transmitting Base Unit by using the On/Off switch on each. The base LED Light will be green when powered ON. Turn off both devices when not in use.
SYNC the meat probe. When both devices are turned on, "SYNC" will appear in the upper left corner of the LCD screen indicating they are synced.
°C/°F Temperature Display Switch between °C and °F using the button on the top side of the thermometer (Handheld Unit).

wireless thermometer buttons like mode button, on/off button and degree Celsius to Fahrenheit button

Insert the probe. Insert the probe tip into the center of the thickest part of the meat, ensuring the tip has not pierced through the other side of the meat. Do not expose any part of the probe to open flame.
Set the temperature. There are 2 Temperature modes: Preset and Manual.
1. Preset: Only "Meat" and "Taste" should be underlined on the LCD screen. Press the MEAT button to scroll through the 8 meat choices: stop when the desired meat choice is highlighted. Press the "Taste" button to scroll through the Meat doneness settings: stop when desired meat doneness appears.
2. Manual: Press the "+" or "-" button to override the Preset Setting and enter into the Manual Setting. Only "TEMP" should be underlined on the LCD screen. Press "+" or "-" to increase or decrease the Set Temperature. Stop when desired Set Temperature is reached.
Set the timer. Press MODE to select TIMER. The timer is selected when underlined. When the count-up or count-down is finished, the thermometer will beep and the LCD screen will flash. Press any key to silence the alert.
1. To set a count-down time, press H/M (Hours/Minutes).
  1. Press once for Hours. Hours will flash when in this setting. Press again for Minutes. Minutes will flash when in this setting.
  2. Press "+" or "-" to increase or decrease the displayed time.
2. To start a count-up without setting a time, press to start from zero.
  1. To pause the timer during a count-down or count-up, to clear the timer, press the button to pause the count-down or count-up.
  2. Once paused, press “+” and “-” at the same time to reset to zero.
When the Current Temperature has reached the Set Temperature, the alarm will beep and the LCD screen will flash. Press any button to silence the alarm.