Understanding the Blender Flash Codes
IMPORTANT: The Blender will not operate at any speed unless the START/PAUSE button is pressed first.
Dial LED is flashing slowly - Ready Mode.
If the LED slowly glows with increasing intensity and then is off, the Blender is ready for blending. Press the START/PAUSE button to start blending.
LED is flashing rapidly - Error Mode
If the LED flashes on/off in rapid bursts, the Blender is not ready for blending. The most common reasons include :
- Pitcher is not properly in place.
- Pitcher was removed before blending was completed.
- Blender is jammed.
First, rotate the knob to “OFF/O.” Next, make sure the pitcher is properly in place. Then, choose your selection and press the START/PAUSE button. If Blender is jammed, it will stop running to avoid damage to the motor. Press START/ PAUSE, then unplug the power cord. Remove the pitcher from the base, and with a scraper, free the blades by breaking up or removing the contents at the bottom of the pitcher. To restart, rotate the knob to the “OFF/O” position, rotate to knob selection, and press START/PAUSE.
LED is not flashing
If the LED does not flash after a setting is selected, the Blender is not ready for blending. The most common reasons include:
- Blender is in “sleep mode.”
- Blender has been unplugged, or a power outage has occurred.
The Blender may have gone into an inactive mode or “Sleep Mode.” This feature saves power if the Blender is left unattended for a few minutes. Resetting the dial to “OFF/O” brings the Blender back into “Active Mode.” First, rotate the knob to “OFF/O.” Next, make sure the pitcher is properly in place. Then, choose your selection and press the START/PAUSE button. If the Blender still does not work, see below for further information on correcting the operation error.
Still need help? Contact us or schedule service.
Please contact us or click below to make an appointment from our preferred list of service providers for service on your appliances.