.png)
.png){kind=icon}
Error Codes - Automatic Coffee Maker
Possible Solutions
Some coffee makers have an LED display which may show an error code. The error codes can mean different things depending upon which model you have.
Models that start with KCM5
| Error Code | Information | Resolution |
|---|---|---|
| Err1 | If the coffee maker is near an outside wall in a cold climate, or if the water is quite cold, this error may display. | Move the coffee maker to a warmer location or us slightly warmer water. |
| Err2 | An electrical component has been dislocated within the coffee maker. | There is no repair for this issue. |
| Err4 | Stuck button | Press and release all buttons on the coffee maker. |
Model: KCM111
Err1 - A button may be jammed. Unplug the coffee maker and press each button several times. Plug the coffee maker into a grounded 3-prong outlet. If “Er1” appears again on the display, repeat this procedure.
Model: KCM1402
Err2 - If the brewing cycle does not complete within 15 minutes, the coffee maker will display an Err2. This can occur if the heater is not working properly.
Model: KCM0802
| Error Code | Information | Resolution |
|---|---|---|
| 1 | It means Motor Error | Reset the unit by unplugging and plugging back in. Then resume brewing. |
| 2 | It means Temperature Sensor Error | Reset the unit by unplugging and plugging back in. Then resume brewing |
| 4 | It means Dry Boil | Add water to the take and resume brewing. |
Model: KCM1202
Er1 - a button may be jammed. Unplug the coffee maker and press each button several times. Plug the coffee maker into a grounded 3-prong outlet. If “Er1” appears again on the display, repeat this procedure.
Model: KCM1208
- Er1 - A button may be jammed. Unplug the coffee maker and press each button several times. Plug the coffee maker into a grounded 3-prong outlet. If “Er1” appears again on the display, repeat this procedure.
- Three Rapid Tones: There is no water in the water tank. Fill the tank and resume the brew cycle.
Model: KCM1402
Cleaning Needed Indicator: Calcium deposits (scale) from water will build up in the coffee maker heat pump over time and impair brewing efficiency and coffee quality. When the coffee maker needs to be cleaned, the “Clean” indicator will flash after a brewing cycle is complete. Once this occurs, descaling should be done as soon as possible to preserve the performance and life of your coffee maker.
For glass carafe models, press the MENU button 5 times to enter the Clean mode. The “Clean” and “ON” indicators will flash. NOTE: For thermal carafe models, press the MENU button 4 times to enter the Clean mode. The “Clean” and “ON” indicators will flash. 5. Press the SET button to program the Clean setting. Two short beeps will sound, indicating programming is complete. Refer to the Owner's Manual for complete instruction on how to clean/descale the coffee maker.