How to Charge the Battery

Last updated
Save as PDF
Share
1. Share
2. Tweet
3. Share

How to Charge the Battery

USING THE USB CABLE

1. Attach the USB cable to the adapter. Connect the other end of the USB cable to the Battery.

1.1_Food Chopper.JPG

2. Plug the USB Adapter into a power source.

1.2_Food Chopper.JPG

USING THE DOCKING STATION (OPTIONAL)

1. Attach the USB cord to the adapter.

2.1_Food Chopper.JPG

2. Plug the adapter into a power source.

2.2_Food Chopper.JPG

3. Turn the Battery upside down and slide the Battery onto the dock.

2.3_Food Chopper.JPG

4. Press down and the latch will snap into place.

5. Upon initial plugging in the Battery into the charger, the Battery LEDs will alternate for a few seconds as it performs a self-diagnostic of the pack status.

2.5_Food Chopper.JPG

6. After diagnostic is complete, the Battery will begin charging with a single LED flashing. LEDs will become solid in color as charging progressives. Battery is fully charged when all LEDs are solid.

NOTE: Should initial alternating light pattern continue for more than 10 seconds, the Battery may be too warm or too cold to charge. Unplug Battery and allow it to stabilize to a normal room temperature and try charging again. If Battery still not charge after this, unplug Battery and contact customer service.

LED INDICATION	BATTERY LEVEL
⚪⚪⚪⚪	75-100%
⚪⚪⚪⚫	50-75%
⚪⚪⚫⚫	25-50%
⚪⚫⚫⚫	< 25%
⛭⚫⚫⚫	When Battery has only 10% Battery level, 1 LED start to flash at rate of 1 second ON/1 second OFF (0.5 Hz).

NOTE: LED Legend Indication:
⚪ = ON ⚫ = OFF ⛭ = FLASH

NOTE: When the Battery is installed or when the appliance is operated, the Battery charge status LEDs will display for 5 seconds and then turn off. If the Battery charge is 10% or less,the indication light will continue to flash until the unit is no longer in use or Battery is removed.

NOTE: It is best to store your appliance at room temperature.