Skip to main content
Product Help | KitchenAid

Attach and Use the Pouring Shield - Stand Mixer

Using the Pouring Shield Kitchen Stand Mixer

Attach the Pouring Shield

A pouring shield prevents flour and wet ingredients from splashing out while mixing.  The chute can be used to add ingredients like eggs and flour while mixing. Many models come with a pouring shield, and if yours did not, they are available for most stainless bowl models.  Pouring shields are not available for glass bowl models.

CLICK HERE to see which model pouring shield fits your mixer.

  1. Make sure the speed control lever is set to the OFF/0 position.
  2. Unplug the stand mixer.
  3. Attach the desired accessory and raise the mixing bowl.
  4. Slide pouring shield collar around beater shaft, centering collar over the rim of the bowl.

NOTE:  For tilt-head models, the open end of the pouring shield should be placed near the body of the mixer.

KN1PS.jpg

Use the Pouring Shield

IMPORTANT: Make sure the guides on the bottom of the chute rest on the rim of the bowl to keep ingredients from falling outside the
bowl as they are added.

  1. Pour ingredients into the mixing bowl through the chute portion of the shield.

Remove the Pouring Shield

  1. Make sure the speed control lever is set to the OFF/0 position.
  2. Unplug the stand mixer.
  3. Remove pouring chute from the collar.
  4. Slide pouring shield collar off the bowl.
  5. Lower the bowl support by turning the bowl-lift lever clockwise (if bowl lift)
  6. Remove accessory and the mixing bowl.

Clean the Pouring Shield

Wash in warm, sudsy water. If you wish, you may place it on the top rack of your dishwasher.

If you would like to download or view product literature for your appliance, please visit our Manuals and Literature page.

 

  • Was this article helpful?