KitchenAid Handle and Knob Accessory Kit Installation
KitchenAid Handle and Knob Accessory Kit Installation
The new KitchenAid handle and knob accessory kits enable you to customize your kitchen appliances with various hardware finishes. Designed to coordinate with kitchen faucets and cabinet pulls, the curated palette of mixed metals complements all KitchenAid® exterior finish options, so you can mix and match with confidence.
Check out KitchenAid Hardware Accessories for more information.
If you have already purchased hardware accessories, this guide will assist you with the installation of the handle and knobs.
Range Installation
Handle Installation
- Loosen the set screws on the underside of the handle using the included tool.
- Pull the handle away from the door and save the set screws
- Place the new handle onto the studs with the screw holes facing downward
- Slide the handle onto the studs until flush with the door
- Hold the handle firmly against the door
- Tighten set screws until the handle is secure
- Do not over-tighten screws
Knob Installation
- Pull the knob away from the unit, removing it from the stem
- Remove the screw holding the bezel in place
- Turn the bezel counterclockwise and pull away
- Secure the new bezel by turning clockwise
- Fasten the bezel in place
- Replace the knob by aligning the crescent shape of the stem
- Pushing firmly until seated
- Repeat for all knobs & bezels
Wall Oven Installation
- Pull knob away from unit, removing it from the stem
- Pull handle away from door and save set screws
- Place new handle onto studs with screw holes facing downward
- Slide handle onto studs until flush with door
- Hold the handle firmly against door
- Tighten set screws until the handle is secure
- Do not over-tighten screws
Refrigerator Installation
- Loosen the set screws on the inside of the handle using the included tool
- Pull the handle away from the door and save the set screws
- Place the new handle onto the studs with the screw holes facing inward
- Slide the handle onto the studs until flush with the door
- Hold the handle firmly against the door
- Tighten set screws until the handle is secure
- Do not over-tighten screws
- Repeat for other handles
Dishwasher Handle Installation
- Loosen the set screws on the underside of the handle using the included tool.
- Pull the handle away from the door and save the set screws
- Place the new handle onto the studs with the screw holes facing downward
- Slide the handle onto the studs until flush with the door
- Hold the handle firmly against the door
- Tighten set screws until the handle is secure
- Do not over-tighten screws